SNAILFLY Roof Rack Crossbars fit for 2011-2021 Jeep Grand Cherokee WK2 with Factory Grooved Side Rails

Perfect fit on my 2014 Jeep grand cherokee.

Fits with minor adjustments.

Straight forward install. However, when you’re securing the cross bars to the mounts. Make sure tighten them in a square( each corner a few turns at a time until secured in place) That’s all.

1. These are a perfect fit for my 2012 Jeep Grand Cherokee!2. There’s no perceivable noise at 65 mph.3. The installation instructions are a little wonky. They show the end pieces as separate parts but were pre-installed on the crossbars. You have to remove the brackets to place them on the rails. Also, the separate rubber gaskets were not on the parts lost but easy to figure out. I’d say the installation took maybe 45 minutes from opening the package to reading the instructions and dry fitting everything to make sure it all fit together through the actual installation. Tools are included. Also included are an extra screw of each size (2). Since the end piece was preinstalled, I didn’t need the second torx wrench.After my test drive, I tightened everything up which just seemed to be due to the gaskets settling in.In a week or so I’ll be transporting my kayak about 150 miles on the freeway and I’ll update if there are any issues but right now I am extremely happy with this purchase!One quick note: These fit perfectly and look OEM but cost only about 1/4 the price of the Mopar crossbars (I don’t know if there’s a difference in load capacity but these will fit my needs.)

Directions bad but usable. Rubber boots supplied not covered in instructions so I will have to take it off and put them on after I figured out they needed to be there. I am putting a cargo carrier on it so to keep it from being scratched I will be putting weather stripping on bottom of cargo carrier. The kind used for trucks when you put on a shell.

This is really a nice product. Great looking low profile on the vehicle and extremely sturdy. I installed it on my 2021 Jeep Grand Cherokee Ltd. Assembly is fairly easy but the instructions are a bit confusing. The rubber pads for the bottoms of the crossbar "feet" are unnecessary, not addressed in the instructions and almost impossible to utilize - I discarded them. Very happy with this product!The wind noise is definitely noticeable so I will go back and change the location of the bars and install the crossbar feet. Although they are not mentioned in the directions, my assumption is that they may be an add-on item intended to reduce wind noise.

Very easy to install. Not sure if they have made improvements based on previous reviews but both bars were marked FRONT and BACK with arrow pointing which way to mount. Also included tools and one extra long and short screw. The small rubber boots that go on the bottom of each bracket were a pain to install but otherwise easy. Took me a total of 45 minutes. Good quality product finish. Drove with them installed and no wind noise at all. See pics. They are low profile and look good on my 2016 grand cherokee.